Tribute DX 4WD V6-3.0L DOHC (2002)
Output Yoke/Flange: Service and Repair
Power Take Off Unit Rear Output Shaft Flange
POWER TAKE OFF UNIT REAR OUTPUT SHAFT FLANGE
Removal
Caution: Mark the driveshaft relative to the companion flange.
1. Remove the driveshaft.
Caution: Rotational torque of the companion flange must be measured and recorded for correct pinion bearing preload when reassembled.
2. Using the special tool, remove the pinion nut.
Caution: Mark the companion flange relative to the pinion spline.
3. Using the special tool, remove the companion flange.
Installation
Caution: Install the companion flange to engage the spline as previously marked.
1. Using the special tool, install the companion flange.
Caution: Do not over tighten the pinion nut.