Tribute LX 2WD V6-3.0L DOHC (2001)
18.
If No Codes are stored press "EXIT". Then the tick mark.
19.
Screen now shows" Set ignition switch to the OFF position". Do this and press tick.
20.
Screen shows" Remove the fuses for fuel pump and cooling fans as this may cause interference and battery drain during the programming
process". Do this and press Tick.
Note:
There are two 50 amp fuses (on 3.0L) labeled "Main Fan" and "Add Fan". Remove only the 50 Amp fuses to deactivate the fans. Fuel pump is a mini
fuse 20 amp (position # 6) at front end of fuse box.
21.
Screen shows " Set ignition switch to the ON position". Do this.
22.
Screen shows "Downloading data" box with "progress bar". Please wait 2-3 minutes.
23.
Screen now shows" Set ignition switch to the OFF position". Do this and press tick.
24.
Screen now shows" Set ignition switch to the ON position". Do this and press tick.
25.
Screen now shows" Set ignition switch to the OFF position". Do this and press tick.
26.
Screen shows "Calibration has been loaded and checked". Press tick.
27.
Screen shows" Re-install fuses for fuel pump and cooling fans". Do this, then press tick.
28.
Screen shows" Obtain a PCM label and fill in the PCM data shown with the date on the WDS screen. Calibration P/N is: 1U7A-12A650-AYD,
2U7A-12A650-CRB, or 3L8A-12A650-BC. Install PCM label next to the vehicle emission label on the hood.
29.
Screen shows "Start engine. Do not depress throttle". Do this and press tick.
30.
Screen shows "operation successful- procedure complete". Press Tick.
31.
Screen now shows "Turn key off" - Do this then press tick.
32.
Vehicle PCM calibration is now updated.
33.
Disconnect WDS cable. Road test vehicle to relearn Keep Alive Memory (KAM).
34.
Go back to REPAIR PROCEDURE Step 4.
