380SL (107.045) V8-3.8L (116.960) (1982)
/v8-3.8l_(116.960)/Page-1184005.png)
Install only steering identified with an "S" into model 107.026. This steering is provided with an additional stop to prevent pitman arm from resting
against exhaust pipe when in steering lock position.
This steering is installed in all left hand steering models starting spring 1979.
Upon repairs following an accident, when one of the side members or the front end have been straightened or replaced, or when the jacket tube has
been removed, check alignment between steering shaft and steering worm. For this purpose, install steering and complete jacket tube without steering
coupling. A vertical and lateral offset between steering shaft and steering worm of 2 mm is permitted. Alignment can be corrected by displacing jacket
tube on cross member or cover plate on front end. Pay attention to perfect location of steering lock cap in cutout of instrument panel.
15. Prior to installation, check steering coupling for wear and recondition or renew, then attach steering coupling to steering shaft.
16. Turn steering to center position. For this purpose, unscrew closing plug from steering housing. Turn steering worm (3) until the center point in
power piston (5) is accurately under threaded bore.
