C 320 CL (203.764) V6-3.2L (112.946) (2004)
Sunroof / Moonroof Interior Trim Panel: Service and Repair
Removing And Installing Sliding/Pop-up Roof Cover
Removing
DANGER:
-
Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate and sliding
roof.
-
When moving components ensure that no body parts or limbs are in the area of movement.
1
Remove rubber bellows from sliding/pop-up roof cover(6)
2
Move sliding/pop-up roof to pop-up position
3
Unscrew Torx screws (2), (3) and (4) from sliding/pop-up roof
4
Unscrew Torx screws (5) from outer support
CAUTION: Only when replacing sliding/pop-up roof cover (6). Left and right side.
5.1 Lift sliding/pop-up roof cover (6) at front and move out of cover carrier (9)
5.2 Remove sliding/pop-up roof cover (6)
NOTE: Only when replacing sliding/pop-up roof cover (6).
Installation
6
Lower pop-up mechanism
CAUTION: Ensure that cover earner (9) is seated correctly on left and right.
7.1 Insert sliding/pop-up roof cover (6) into cover carrier (9) from front.
CAUTION: Ensure that sheet metal lug (7) is seated properly.Left and right side
7.2 Position sliding/pop-up roof cover (6)
NOTE: Only when replacing sliding/pop-up roof cover(6)
8
Screw in Torx screws (2) on front sliding/pop-up roof
CAUTION: Replace screws