E 320 4MATIC Wagon (210.282) V6-3.2L (112.941) (1998)
1. First disconnect brake hose (51) on brake pipe (5) and then on fixed caliper (31).
-
Immediately seal connections with plugs.
-
The brake fluid reservoir must not empty completely.
2. Disconnect rear brake pad wear pad wear sensor (S10/4) at rear brake pad wear sensor connector.
3. Unscrew right rear brake pad wear sensor connector (S10/4x1)
4. Unscrew micro-encapsulated bolts (35) then remove fixed caliper (31) from wheel carrier.
Installation:
5. Install in reverse order, noting the following.
-
Replace micro-encapsulated bolts (35), tighten to:
Model 140: 115 Nm
Models129.05/060/061/063/064/066/067: 50 Nm.
Models129.068/076: 70 Nm
Model 170: 50 Nm
Model 202 except 202.028 with ASR: 50 Nm
Model 202.028 with ASR: 70 Nm
Models208.335/345/347/365/370/435/445/447/465/470: 50 Nm
Models210.00/01/02/03/04/05/070/072/08 except 210.072 with Code 957 (E50 AMG): 50 Nm
Models210.20/21/22/23/24/26/27/270/272/28/60/61/663: 115 Nm
NOTE:
^
Install the transparent (temperature-resistant) version of the brake pad wear sensor (S10/4).
^
The wear sensor on the rear fixed caliper is not used anymore on model 202.028 with ASR as of 09/95.
-
Tighten brake pipe (5) on brake hose (51) to:
Except model 210 14 Nm
Model 210: 18 Nm
-
Tighten brake hose (51) on fixed caliper (31) to: 18 Nm
-
Refer to Replacement, for notes on installing brake hoses. See: Hydraulic System/Brake Hose/Line/Service and Repair
NOTE:
^
Brake hose connection on brake pipe modified.
^
The versions must not be mixed up
-
Refer to notes on installing brake pad wear indicator contact sensors. See: Brake Pad/Brake Pad Wear Sensor/Service and Repair
6. Bleed brake system. See: Brake Bleeding/Service and Repair
7. Check brake system for leaks, refer to Using Pedal Pressure. See: Hydraulic System/Testing and Inspection
With AMG Engineering Package
NOTE: For model name/model number cross reference refer to Model Designation Table. See: Application and ID