GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) (2010)
2. Clean painted adhesive surface (area B) on body flange of rear-end door with cleaner from 2-component repair kit for installing glued windows
and dry with drying cloth.
3. Remove loose glue residues from body flange.
If glue residues are damaged or missing on the body flange, apply primer in area to be glued. Then allow primer to air-dry completely (min. 10
min.)
4. Repair paint damages on body flange not covered by glue with primer pin.
To avoid poor adhesion when installing window, adhesive surfaces of body flange of rear-end door must be free of dust, oil, grease, wax, dirt
residues and other anti-adhesive components.
AR67.20-P-3550-01GZ Cut Out Window With Cutting Blade
AR67.20-P-3550-01GZ Cut Out Window With Cutting Blade
DANGER: Risk of injury caused by slipping when clamping blade in the multicutter and by glass splinters when cutting out bonded windows
Always interrupt air supply when inserting or removing blade. Wear protective gloves and safety glasses.
Workshop Equipment
1. Secure rear-end door window against falling down using fabric tape in area A.
2. Clamp straight blade into multicutter.