S 600 (220.176) V12-5.5L Turbo (275.960) (2005)
6
Separate front propeller shaft (1) and rear propeller shaft (2) at the slide connection
NOTE: Installation: Assemble propeller shaft Coat splined profile with Molykote grease.
Inspect
7
Check centering sleeve (10) in front propeller shaft (1) and rear propeller shaft (2)
NOTE: If sealing lip in centering sleeve (10) is worn or damaged, the centering sleeve (10) can be replaced separately.
8
Remove centering sleeve (10)
-
If necessary, after inspecting.
NOTE: Installation: Press in centering sleeve
9
Fill cavities of both centering sleeves with grease
10
Install in the reverse order.
AR41.10-P-0050I Remove/Install Propeller Shaft
Remove/Install Propeller Shaft
Illustration Shows Propeller Shaft With Three-arm Flange
Remove/install
CAUTION: See notes on self-locking nuts and bolts
DANGER:
-
Risk of death. Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
1
Raise vehicle.
2
Remove exhaust system as of flange connection
3
Detach reinforcement brace (35)
NOTE: With model 220.074/174 spacers are below the reinforcement brace.
4
Detach front exhaust shielding plate (105k) from exhaust shielding plate above center muffler (105e)
NOTE: Installation: Install new sheet metal screws and sheet metal nuts.