SL 600 (129.076) V12-6.0L (120.983) (1997)
/v12-6.0l_(120.983)/Page-1472002.png)
-
Check installed position of center assembly in rear axle carrier as follows:
-
Position test device (01) of removal/installation tool with spacers(14) and thrust pieces (15) on both sides, with the existing threaded
spindles and nuts and tighten loosely (014, 015)
-
Draw two rubber mounts (62) evenly into the rear axle carrier (1) until the pin (arrow) of the test device (01) is in the center of the hole in
the rear axle cross member
-
Install front center assembly suspension as follows:
1. Install rubber mount (60b) and short 14 mm disk (60a) at top in rear axle carrier (1)
2. Install the rubber mount with guide collar (60c) and long 17 mm disk (60d) at bottom
-
Ensure bearing is properly seated
3. Install assigned shim (60e) between disk (60d) and rear axle center assembly (50)
4. Replace self-locking hex nut (52) and install rear axle center assembly (50) on rear axle carrier (1),
