SLK 320 (170.465) V6-3.2L (112.947) (2002)
AR41.10-P-0100-05DA Pressing rubber mount with grooved ball bearing onto joint fork
Special Tools
Component Identification
The open side of the grooved ball bearing must point backwards.
1
Press rubber mount (7) with grooved ball bearing onto linkage arm using drift (05).
126 589 03 15 00 use with grooved ball bearing dia. of 32 mm.
201 589 07 15 00 use with grooved ball bearing dia. of 27 mm.
AR41.10-P-0200-02DA Removal of Centering Sleeve
AR41.10-P-0200-02DA Removal of centering sleeve
Component Identification
1
Before removing the centering sleeve, measure and note the press-in dimension "a".
Depending on the version of flexible disk (for example, on vehicles with vibration damper) it may lead to a deviation between the measured and
the specified press-in dimension "a". Then the measured press-in dimension "a" is to be taken into account before removal.