SLK 320 (170.465) V6-3.2L (112.947) (2002)
2
Knock centering sleeve evenly out of propeller shaft (arrow) using a flat chisel.
Component Identification
If it is not possible to hammer out the centering sleeve using a chisel:
3
Drill a hole (dia. 10 mm) 15 mm from the end face of the centering sleeve (10) at right-angles through the centering sleeve.
Component Identification
4
Insert a drift through the bore and lever the centering sleeve (10) out of the propeller shaft using two assembly levers.
AR41.10-P-0100-01DA Pulling Off Rubber Mount With Grooved Ball Bearing and Front Protective
Cap
AR41.10-P-0100-01DA Pulling off rubber mount with grooved ball bearing and front protective cap