Grand Marquis V8-4.6L Flex Fuel (2010)
Remove the driveshaft from the C-Frame and Screw Installer/Remover and install the snap ring.
10. Repeat Steps 8 and 9 for the opposite side.
11. Install a new bearing cup.
1. Start a new bearing cup into the driveshaft slip yoke.
2. Position the slip yoke on the spider.
3. Install the driveshaft into the C-Frame and Screw Installer/Remover.
4. Press the bearing cup 6.3 mm (0.25 in) below the yoke surface.
12. NOTE: Use the yellow snap rings supplied in the universal kit. If difficulty is encountered installing the yellow snap rings, install the black snap
rings also supplied in the kit.
Remove the driveshaft from the C-Frame and Screw Installer/Remover and install the snap ring.
13. Repeat Steps 11 and 12 for the opposite side.
14. NOTE: Do not strike the bearings. If binding, strike the yoke with a brass or plastic hammer to seat the bearing cups.
Check the U-joint for freedom of movement.
