Mariner 2WD L4-2.5L (2009)
-
Disconnect: SJB Fuses 37 (10A) and 15 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test L. See: Pinpoint Test L: The HVAC Module Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. GO to T7.
-------------------------------------------------
T7 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE ACM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 39 (20A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test K. See: Pinpoint Test K: The Audio Control Module (ACM) Does Not Respond To The Scan Tool
No
If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), INSTALL the removed fuse. GO to T8.
If the vehicle is not equipped with an APIM, INSTALL the removed fuse. GO to T9.
-------------------------------------------------
T8 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 3 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test P. See: Pinpoint Test P: The Accessory Protocol Interface Module (APIM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuses. GO to T9.
-------------------------------------------------
T9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE FCIM, FDIM AND/OR SDARS MODULE DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 14 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?