Mariner 2WD L4-2.5L (2009)
Yes
For vehicles equipped with an FDIM only, INSTALL the removed fuse. Go To Pinpoint Test N. See: Pinpoint Test N: The Front Display Interface
Module (FDIM) Does Not Respond To The Scan Tool
For vehicles also equipped with an FCIM and/or a SDARS module, INSTALL the removed fuse. GO to T10.
No
INSTALL the removed fuse. GO to T13.
-------------------------------------------------
T10 VERIFY VEHICLE EQUIPMENT - FCIM
-
Inspect the vehicle for an FCIM.
-
Is the vehicle equipped with an FCIM?
Yes
GO to T11.
No
GO to T12.
-------------------------------------------------
T11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE FCIM DISCONNECTED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: FCIM C2402.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the FCIM. Go To Pinpoint Test O. See: Pinpoint Test O: The Front Controls Interface Module (FCIM) Does Not Respond To The Scan
Tool
No
CONNECT the FCIM. GO to T12.
-------------------------------------------------
T12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE SDARS MODULE DISCONNECTED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SDARS Module C3290.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the SDARS module. Go To Pinpoint Test M. See: Pinpoint Test M: The Satellite Digital Audio Receiver System (SDARS) Module Does
Not Respond To The Scan Tool
No
CONNECT the SDARS module. Go To Pinpoint Test N. See: Pinpoint Test N: The Front Display Interface Module (FDIM) Does Not Respond To The
Scan Tool