Milan FWD L4-2.5L (2010)
3. Position the rear door window glass at the top of the door.
4. Loosen the exterior door handle reinforcement bolt.
-
To install, tighten to 6 Nm (53 lb-in).
5. Slide the exterior rear door handle reinforcement to the front of the vehicle and push inside the door.
6. Remove the 3 rear door latch bolts.
-
To install, tighten to 8 Nm (71 lb-in).
7. Remove the complete latch, carrier, and handle reinforcement assembly from the door.
8. Open the clip and disconnect the exterior rear door handle actuating rod.
9. Remove the 2 screws and remove the rear door latch from the carrier.
10. To install, reverse the removal procedure.
Door Latch Release Cable
Door Latch Release Cable
NOTE: LH front shown, other doors similar.
Removal and Installation
1. Remove the door window regulator and motor. For additional information, refer to Windows and Glass.
2. Remove the exterior door handle. For additional information, refer to Exterior Door Handle See: Front Door/Front Door Handle/Front Door
Exterior Handle/Service and Repair/Exterior Door Handle.
3. On the rear doors, position the door window glass at the top of the door.
4. Loosen the exterior door handle reinforcement bolt.
-
To install, tighten to 6 Nm (53 lb-in).