Milan FWD L4-2.5L (2010)
Climate controlled seat
17. Disconnect the Thermo-Electric Device (TED) assembly electrical connector and detach the wiring harness retainers.
18. Remove the TED exhaust duct.
-
Cut and remove the tie strap.
-
Remove the retainer and separate the exhaust duct from the TED.
19. Disconnect the backrest upper support spring from the backrest frame and remove the spring support with the TED attached.
-
Use an appropriate tool and separate the TED from the upper backrest support spring.
-
Note the TED position on the support spring for installation.
Seat with power recliner
20. Remove the one-way push clip on the RH side of the power recliner. Slide the recliner shaft out from the LH side of the seat enough to clear the
RH recliner and power recline motor.
21. Disconnect the electrical connector, remove the bolt and the power recline motor.
All seats
22. Remove the 2 nuts and side air bag mounting bracket.
23. Detach any pin-type retainers, route out and remove the wiring harness, if equipped.
Assembly
All seats
1. Route and install the backrest wiring harness, if removed.
2. Install the side air bag mounting bracket and 2 nuts, if removed.
-
Tighten to 6 Nm (53 lb-in).
Seat with power recliner
3. NOTE: The recliners are synchronized. Avoid rotating the recliner shaft until fully installed.
Install the recliner motor in the following sequence.
1. Position the recliner shaft through the recliner motor and RH recliner.
2. Install a new one-way push clip onto the recliner shaft at the RH recliner.
3. Slightly turn the recliner motor to align the bolt hole with the hole in the RH recliner and install the recliner motor bolt.
-
Tighten to 6 Nm (53 lb-in).
4. Connect the recliner motor electrical connector.