Milan FWD L4-2.5L (2010)
6. Remove the backrest latch.
-
Remove the 2 nuts and backrest latch.
Installation
Non-hybrid vehicles
1. Attach the release cable to the latch.
2. Route the release cable, position the release handle and bracket to the 2 studs and install the 2 nuts.
-
Tighten to 9 Nm (80 lb-in).
-
Install the 2 release cable pin-type retainers.
-
Position the trim and install the pin-type retainer.
All vehicles
3. Position the latch and install the nuts.
-
Adjust the latch. For additional information, refer to Seat Latch Adjustment - Rear See: Adjustments in the General Procedures portion.
-
Tighten to 48 Nm (35 lb-ft).
4. Install the parcel shelf.