Milan FWD L4-2.5L (2010)
-
Hybrid vehicles: To install, tighten to 20 Nm (177 lb-in).
4. NOTICE: Use only hand tools to remove and install the fasteners or damage to the booster may occur.
Remove the 2 brake master cylinder nuts.
-
To install, tighten to 20 Nm (177 lb-in).
5. Remove the brake master cylinder.
6. NOTICE: Do not allow the flexible portion of the brake tubes to twist during installation, or damage to the brake tubes may occur.
To install, reverse the removal procedure.
-
Bleed the master cylinder. For additional information, refer to Brakes and Traction Control.
-
If equipped with a manual transmission, bleed the clutch master cylinder. For additional information, refer to Manual Transmission/Transaxle
&/or Clutch, M/T.
Brake Fluid Reservoir
Brake Fluid Reservoir
2.5L Non-Hybrid
NOTE: Automatic transmission shown, manual transmission similar.
2.5L Hybrid, 3.0L and 3.5L