Milan FWD L4-2.5L (2010)
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
All vehicles
1. Using a suitable suction device, remove the brake fluid from the remote reservoir.
2. Disconnect the brake fluid level switch electrical connector.
2.5 Hybrid, 3.0L and 3.5L vehicles
3. Remove the lower cowl panel grille.
4. Disconnect the hose from the remote reservoir.
5. Disconnect the brake fluid level switch harness from the brake fluid reservoir.