Milan FWD L4-2.5L (2010)
No
INSTALL the removed fuse. GO to AB18.
-------------------------------------------------
AB17 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE DDM DISCONNECTED
-
Disconnect: DDM C568b .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
Yes
CONNECT the DDM. GO to Pinpoint Test X. See: Pinpoint Test X: The Driver Door Module (DDM) Does Not Respond To The Scan Tool
No
CONNECT the DDM. GO to Pinpoint Test Z. See: Pinpoint Test Z: The Driver Seat Module (DSM) Does Not Respond To The Scan Tool
-------------------------------------------------
AB18 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IPC DISABLED
-
Disconnect: SJB Fuses 26 (15A) and 29 (5A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
Yes
INSTALL the removed fuses. GO to Pinpoint Test C. See: Pinpoint Test C: The Instrument Panel Cluster (IPC) Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. If the vehicle is equipped with a Parking Aid Module (PAM) and/or side obstacle detection, GO to AB19.
If the vehicle is not equipped with a PAM and/or side obstacle detection, an intermittent fault is not present. GO to Pinpoint Test AC. See: Pinpoint Test
AC: No Medium Speed CAN (MS-CAN) Communication, All Modules Are Not Responding
-------------------------------------------------
AB19 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE PAM (IF EQUIPPED), SOD-L (IF EQUIPPED) AND
SOD-R (IF EQUIPPED) DISABLED
-
Disconnect: SJB Fuse 35 (10A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
Yes
If the vehicle is equipped with only a PAM, INSTALL the removed fuse. GO to Pinpoint Test T. See: Pinpoint Test T: The Parking Aid Module (PAM)
Does Not Respond To The Scan Tool
If the vehicle is equipped with only side obstacle detection, INSTALL the removed fuse. GO to AB21.
If the vehicle is equipped with both a PAM and side obstacle detection, INSTALL the removed fuse. GO to AB20.
No
INSTALL the removed fuse. An intermittent fault is not present. GO to Pinpoint Test AC. See: Pinpoint Test AC: No Medium Speed CAN (MS-CAN)