Milan FWD L4-2.5L (2010)
Communication, All Modules Are Not Responding
-------------------------------------------------
AB20 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE PAM DISCONNECTED
-
Disconnect: PAM C4014 .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
Yes
CONNECT the PAM. GO to Pinpoint Test T. See: Pinpoint Test T: The Parking Aid Module (PAM) Does Not Respond To The Scan Tool
No
CONNECT the DDM. GO to AB21.
-------------------------------------------------
AB21 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE SOD-L DISCONNECTED
-
Disconnect: SOD-L C4230 .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other MS-CAN modules pass the network test?
Yes
CONNECT the SOD-L. GO to Pinpoint Test R. See: Pinpoint Test R: The Side Obstacle Detection Control Module - Left (SOD-L) Does Not Respond
To The Scan Tool
No
CONNECT the SOD-L. GO to Pinpoint Test S. See: Pinpoint Test S: The Side Obstacle Detection Control Module - Right (SOD-R) Does Not Respond
To The Scan Tool
-------------------------------------------------
AC1-AC34
Communications Network
Pinpoint Tests
Pinpoint Test AC: No Medium Speed Controller Area Network (MS-CAN) Communication, All Modules Are Not Responding
Refer to Wiring Diagram Set 14 (Fusion/Milan/MKZ, Fusion Hybrid/Milan Hybrid), Module Communications Network for schematic and connector
information. See: Diagrams/Electrical Diagrams/Diagrams By Number
Normal Operation
The Medium Speed Controller Area Network (MS-CAN) uses an unshielded twisted pair cable, circuits VDB06 (GY/OG) and VDB07 (VT/OG).
This pinpoint test is intended to diagnose the following:
-
Wiring, terminals or connectors
-
Accessory Protocol Interface Module (APIM) (if equipped)
-
Audio Control Module (ACM)
-
Audio Digital Signal Processing (DSP) module (if equipped)
-
Driver Door Module (DDM) (if equipped)
-
Driver Seat Module (DSM) (if equipped)