Milan FWD V6-3.0L (2010)
7. Release the first cushion cover J-clip from the rear of the cushion frame and disconnect the side air bag wiring harness electrical connector.
8. Detach the side air bag wiring harness electrical connector pin-type retainer from the cushion frame.
9. NOTE: Electrical connectors vary with power seat options.
Disconnect the backrest power feed electrical connector(s) and route out the wire harness.
-
Release the wire harness retainers.
Seat with manual lumbar
10. Remove the 2 rivets and separate the manual lumbar control from the cushion frame.
11. Detach the lumbar control from the cable and remove.
-
Detach any cable retainers from the cushion frame.
-
Note the manual lumbar cable routing for installation.
All seats
12. Remove the 4 recliner-to-cushion frame bolts and remove the backrest assembly.
-
Route out the wire harness(es) and manual lumbar cable, if equipped.
-
Note routing for installation.
-
To install, tighten to 55 Nm (41 lb-ft).
13. To install, reverse the removal procedure.
14. Install the seat. For additional information, refer to Seat - Front See: Service and Repair/Seat - Front.
Seat Backrest - Front, With Fold Flat
Seat Backrest - Front, With Fold Flat
Removal and Installation
NOTICE: Do not reinstall the cushion side shield or side shield retainers after removal. These are one-time-use items that become damaged
during removal and may not remain attached if reinstalled. Install a new side shield during seat assembly (includes new retainers attached).
NOTE: Only the front passenger seat can be equipped with optional fold-flat backrest.
1. Remove the front seat. For additional information, refer to Seat - Front See: Service and Repair/Seat - Front.
2. Remove the spring clip and manual recliner handle.
3. Remove and discard the cushion side shield and one-time-use retainers.
1. Pull out on the side and rear of the cushion side shield and release the retainers.