Milan FWD V6-3.0L (2010)
If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to AE37.
If the vehicle is not equipped with an APIM, GO to AE38.
-------------------------------------------------
AE37 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE APIM DISCONNECTED
-
Disconnect: APIM C3338 .
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.
-
Are the resistances greater than 1,000 ohms?
Yes
CONNECT the negative battery cable. GO to AE51.
No
For gasoline engine, REPAIR the circuits. CONNECT all modules. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test
with the scan tool.
For hybrid, GO to AE39.
-------------------------------------------------
AE38 VERIFY VEHICLE EQUIPMENT - HYBRID
-
Verify whether the vehicle is a hybrid.
-
Is the vehicle a hybrid?
Yes
GO to AE39.
No
REPAIR the circuits. CONNECT all modules. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
AE39 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE ACCM DISCONNECTED
-
Disconnect: Air Conditioning Compressor Module (ACCM) C1469a .
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.
-
Are the resistances greater than 1,000 ohms?
Yes