Milan FWD V6-3.0L (2010)
10. Position the main control cover in place.
11. NOTICE: Inspect the main control-to-main control cover grommet to make sure that the seal is on the inside of the main control cover or
a transmission fluid leak will occur.
NOTE: Install the stud bolts in the locations noted during disassembly.
Tighten the 8 main control cover bolts and 5 stud bolts.
-
Tighten to 12 Nm (106 lb-in).
12. Position the transmission fluid cooler tube bracket and transmission fluid cooler tube assembly in place and install the 2 nuts.
-
Tighten to 9 Nm (80 lb-in).
13. Connect the transaxle electrical wiring harness retainers to the main control cover stud bolts.
