Milan FWD V6-3.0L (2010)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the driveshaft. For additional information, refer to Drive/Propeller Shafts, Bearings and Joints.
3. Using the Drive Pinion Flange Holding Fixture, hold the pinion flange and remove the pinion flange nut.
-
Discard the nut.
4. Index-mark the location of the pinion flange to the yoke.
5. Using the 2 Jaw Puller, remove the pinion flange.
6. Using the Converter Seal Remover and Slide Hammer, remove and discard the drive pinion seal.
Installation
