Montego AWD V6-3.0L VIN 1 (2005)
Rear Door Window Glass: Service and Repair
Rear Door Window Glass
REAR DOOR WINDOW GLASS
Removal and Installation
All vehicles
1. Remove the rear door trim panel.
2. Remove the access hole plug.
3. NOTE: If the door window regulator is inoperative, remove it.
Lower the window until the glass clamp bolt is accessible through the access hole plug, then loosen the glass clamp bolt.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
Freestyle only
5. Lower the window glass into the door.
6. Remove the top run.
7. Remove the rear fixed window glass.
-
Remove the bolt and the screw.
Montego, Five Hundred
8. Lower the window glass into the door.