Montego AWD V6-3.0L VIN 1 (2005)
been exposed, a new safety canopy module must be installed. Do not attempt to repair the safety canopy module. Failure to follow these
instructions can result in personal injury in the event of a safety canopy module deployment.
-
Never put any type of fastener or tie strap around any part of the safety canopy module or interior trim panel. This will prevent the safety
canopy module from deploying correctly. Failure to do so can result in personal injury in the event of a safety canopy module deployment.
Position safety canopy module in vehicle.
-
Route the safety canopy module back through the rear window defroster wiring harness.
4. Install the front and rear safety canopy module guide bolts
-
Tighten bolt to 7 Nm (62 lb-in).
5. Attach the safety canopy module rear bracket pin type retainer.
6. NOTE: Make sure all safety canopy module bolt holes line up with all J-clips.
Connect the safety canopy module electrical connector and install the safety canopy module 2 rear bracket bolts while making sure the pin type
retainer is fully seated.
-
Tighten bolts to 7 Nm (62 lb-in).