Mountaineer 4WD V6-245 4.0L VIN X SFI (2000)
Transmission Speed Sensor: Service and Repair
Transfer Case - Automatic Shift
Output Shaft Speed Sensor-Front
Removal
1. Remove the transfer case shift motor.
2. Remove the front output shaft speed sensor.
1. Remove the bolt.
2. Remove the front output shaft speed sensor.
Installation
1. CAUTION: Make sure the sensor seats flat against the boss.
To install, reverse the removal procedure.
Output Shaft Speed Sensor-Rear
Removal
Warning: The electrical power supply to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the rear jack storage area. Failure to do so can result in
unexpected inflation or deflation of the air springs which can result in shifting of the vehicle during these operations.
1. Raise and support vehicles.
2. Disconnect the electrical connector.