Mystique V6-153 2.5L DOHC VIN L SFI (1999)
1. Prior to installation, clean the valve cover sealing surfaces using a shop towel and Metal surface cleaner.
-
Install a new gasket on the valve cover.
-
Use Silicone gasket and sealant.
2. Tighten the valve cover bolts in the indicated sequence.
3. Install the wiring harness shield on the right-hand valve cover.
4. Install the wiring harness on the rear of the right-hand valve cover.
5. Install the in-line connector bracket to the right-hand valve cover.
6. NOTE: Make sure the ground cable is in place when installing the ignition coil.