mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Axle Shaft|Removal and Installation|Page 5093 > < Axle Shaft|Removal and Installation|Page 5091
Page 4
background image

Disconnect the left-hand halfshaft.

CAUTION: To avoid damage to the CV joints and boots, do not bend the inner CV joint by more than 18 degrees, the outer CV joint by
not more than 45 degrees.
 

11. NOTE:  Oil escapes. Close off the transaxle opening with blanking plugs.

Disconnect the halfshaft (vehicle with MTX-75 manual transaxle shown).

Installation 

l.

Install a new snap-ring.

CAUTION:  To avoid damage to the CV joints and boots, do not bend the inner CV joint by more than 18 degrees, the outer CV joint by
not more than 45 degrees
.

2. NOTE:  Do not damage the oil seal. Check that the snap-ring engages correctly.

Axle Shaft|Removal and Installation|Page 5093 > < Axle Shaft|Removal and Installation|Page 5091