Sable V6-183 3.0L DOHC VIN S MFI (1997)
7.
If necessary, Repeat this procedure for the opposite front caliper.
8. If necessary, Repeat this procedure for the opposite diagonal system.
9. After disc brake service, make sure disc brake pistons are returned to their normal positions and shoe and lining assemblies are properly seated.
This is accomplished by applying brake pedal several times until normal pedal travel is established.
10. Check pedal feel. If brake pedal feels spongy repeat bleed procedure,perform additional bleeding procedures, Refer to Brakes - Service and
Repair, or perform diagnosis procedure. See: Brake Bleeding/Service and Repair See: Testing and Inspection/Symptom Related Diagnostic
Procedures
11. Fill brake master cylinder with specified brake fluid to between MAX line and 4 mm (0.16 inch) below MAX line on reservoir. Use High
Performance DOT-3 Motor Vehicle Brake Fluid .
CAUTION:Failure to tighten lug nuts in a star pattern may result in high rotor runout, which will speed up the development of brake roughness,
shudder and vibration.
12. Install wheel and tire assembly on vehicle. Tighten lug nuts to 115-142 Nm (85- 104 ft.lbs) using Accutorq Lug Nut Socket or equivalent on a 1/2
inch air impact wrench, or use a torque wrench.
13. Lower vehicle.
14. Road test vehicle.