Sable V6-183 3.0L DOHC VIN S MFI (1997)
-
When adjusting the rear brake shoes and linings, check the parking brake lever for proper adjustment and freedom of movement.
-
Refer To: Parking Brake for servicing. See: Parking Brake System
-
Make sure that the adjuster mechanism operates freely with the brake shoes and linings centered on the rear brake backing plate.
MANUAL DRUM ADJUSTMENTS
1. Apply a small quantity of Silicone Brake Caliper Grease and Dielectric Compound to points where the shoes contact the rear brake backing plate.
Do not get lubricant on linings.
2. Determine inside diameter of the drum braking surface using a brake adjustment gauge.
3. Adjust the brake shoes and lining's diameter to fit the gauge. Line the brake shoes and linings up vertically so the flats on the bottom of the brake
shoes and linings are aligned approximately 1.5mm (0.05 inch) above the bottom of the brake shoe abutment plate before setting the gauge
diameter.
4. Hold automatic brake shoe adjusting lever out of engagement while rotating adjusting screw. Lubricate if necessary. Make sure adjusting screw
rotates freely. Refer to Brake Shoe/Service & Repairfor adjuster service. See:
5. Rotate brake adjustment gauge around brake shoes and linings to make sure of proper setting.
6. Install brake drum.
7. Install tire and wheel assembly. Tighten lug nut to 115-142 Nm (85-104 ft. lbs.). Do not use power or impact-type tools; use a torque wrench.
8. Install the wheel cover and nut covers as required.
9. Complete adjustment by applying brake pedal several times with a minimum of 111 Nm (25 lbs) force.
10. After brake shoes and linings have been properly adjusted, check operation of brakes by making several stops from varying forward speeds.
