Sable V6-183 3.0L DOHC VIN S MFI (1997)
Brake Hydraulic Hose, To Wheel Cylinder
REMOVAL
1. Raise and support vehicle.
2. Remove wheel and tire assembly.
3. Remove rear brake tube and rear brake tube from rear hose and connector.
4. Remove two screws retaining rear hose and connector to rear side rail and rear strut bracket.
INSTALLATION
1. Position rear hose and connector on rear side rail. Install retaining screws to rear side rail and rear strut bracket. Tighten retaining screws to 12-15
Nm (107-132 inch lbs.).
2. Connect LH rear brake tube to rear hose and connector. Tighten to 16-20 Nm (12-14 ft.lbs).
3. Bleed the rear hose and connector through the nearest rear wheel cylinder as described. Fill brake master cylinder to MAX mark.
CAUTION: Failure to tighten lug nuts in a star pattern may result in high rotor runout, which will speed up the development of brake roughness,
shudder and vibration.
4. Install wheel and tire assembly using Accutorq(r) or equivalent or torque wrench. Tighten lug nuts to 115-142 Nm (85-104 ft.lbs).
5. Lower vehicle.
Disc Brake
