Sable V6-183 3.0L DOHC VIN S MFI (1997)
REMOVAL
1. Apply service brake pedal several times to exhaust all vacuum in the system.
2. Disconnect brake fluid level warning switch connector.
3. Remove brake tubes from primary and secondary outlet ports of brake master cylinder.
4. Remove nut retaining cowl top inner panel tube (02206) to brake master cylinder.
5. Disconnect cowl top inner panel tube from cowl and remove.
6. Remove two nuts retaining brake master cylinder to power brake booster assembly.
7. Slide brake master cylinder forward and upward from vehicle.
DISASSEMBLY
NOTE: If brake master cylinder is to be put into vise to aid in disassembly, mount into vise by flange only to avoid damage to bore or reservoir
areas.
1. Clean outside of brake master cylinder thoroughly. Remove brake master cylinder filler cap.
2. Drain all brake fluid from brake master cylinder. Always discard used brake fluid.
3. Remove primary brake master cylinder reservoir port from brake master cylinder by prying upward with rod or long screwdriver.
4. Remove secondary brake master cylinder reservoir port in same manner
