Sable V6-183 3.0L DOHC VIN S MFI (1997)
1. Apply service brake pedal several times to exhaust all vacuum in the system.
2. Disconnect brake fluid level warning switch connector.
3. Remove brake tubes from primary and secondary outlet ports of brake master cylinder.
4. Remove nut retaining cowl top inner panel tube (02206) to brake master cylinder.
5. Disconnect cowl top inner panel tube from cowl and remove.
6. Remove two nuts retaining brake master cylinder to power brake booster assembly.
7. Slide brake master cylinder forward and upward from vehicle.
INSTALLATION
1. Position brake master cylinder on studs on power brake booster assembly.
2. Install retaining nuts. Tighten to 26-39 Nm (20-28 ft.lbs).
3. Connect cowl top inner panel tube to cowl.
4. Install nut retaining cowl top inner panel tube to brake master cylinder and tighten to 21-29 Nm (16-21 ft.lbs).
5. Install primary and secondary brake tubes to brake master cylinder outlet ports. Tighten to 16-20 Nm (12-14 ft.lbs).
6. Connect brake fluid level warning switch connector.
7. Fill brake master cylinder reservoir with specified brake fluid to MAX line with High Performance DOT-3 Motor Vehicle Brake Fluid.
8. Bleed brake system.
