mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Rear Cable and Conduit|Page 8877 > < Rear Cable and Conduit|Page 8875
Page 2
background image

10. Apply the park brake pedal a few times and verify that the rear brakes do not drag when the rear wheels rotate.
11. Verify that the manual release parking brake control lever stroke is five to seven notches when applied with a foot-pedal force of 98 N (22 lb).

RH Rear Cable Service

REMOVAL

1. Raise and support vehicle.
2. Remove RH rear wheel/tire assembly.

3. Loosen parking brake cable adjusting nut.

Park Brake Equalizer

4. Disconnect LH parking brake rear cable and conduit from parking brake cable equalizer.
5. Use a 13mm box-end wrench or screwdriver to compress conduit retainer prongs and remove RH parking brake rear cable and conduit from 

parking brake cable equalizer

6. Push plastic snap-in grommet rearward to disconnect from inner floor side member brackets.
7. Disc brakes:

Rear Cable and Conduit|Page 8877 > < Rear Cable and Conduit|Page 8875