Sable V6-183 3.0L DOHC VIN S MFI (1997)
Weld both ends of the bracket completely (Figure 4).
Cut a section approximately 1/2 inch (13 mm) wide, from the original NVH bracket (Figure 5).
Install exhaust as per Section 09-00 of the Workshop Manual.
Weld both ends of the bracket completely (Figure 4).
Cut a section approximately 1/2 inch (13 mm) wide, from the original NVH bracket (Figure 5).
Install exhaust as per Section 09-00 of the Workshop Manual.