mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Air Door Actuator|Page 10923 > < Air Door Actuator|Page 10920
Page 1
background image

Air Door Actuator / Motor: Service and Repair
Air Door Actuator

Air Inlet Door

 
REMOVAL

1. Remove A/C recirculating air duct.
2. Remove two screws retaining A/C air inlet duct door vacuum control motor.
3. NOTE:  Do not attempt to bend any part of the pivot shaft; it is brittle and will break.

Rotate vacuum control motor and disengage arm from pivot shaft.

INSTALLATION

1. Follow removal procedure in reverse order.

Heater Air Damper Door

REMOVAL

1. Remove instrument panel.
2. Disconnect air bag diagnostic monitor electrical wiring connectors.

Air Door Actuator|Page 10923 > < Air Door Actuator|Page 10920