Sable V6-183 3.0L DOHC VIN S MFI (1997)
A/C Coil Pressing Tool - Installation
3. Place the Coil Pressing Tool T89P-19623-EH with Field Coil Replacer T91L-19623-CH in position over the compressor nose and to the inner
radius of the A/C clutch field coil.
4. Position 2-Jaw Puller D8OL-1002-L or equivalent on the A/C compressor and coil pressing tool. The jaws of the puller should be firmly engaged
with the rear side of the A/C compressor front mounts. The forcing screw must be piloted on the center mark of the pressing tool.
5. Tighten the forcing screw with a hand wrench until the A/C clutch field coil is pressed on the A/C compressor front head. Check to make sure that
the A/C clutch field coil bottoms against the head at all points around the coil outer diameter.
6. Install the A/C clutch pulley and A/C clutch on the A/C compressor.
7. Check and adjust air gap as described in Adjustments.
8. Install the A/C compressor on the vehicle.