Sable V6-183 3.0L DOHC VIN S MFI (1997)
5. Remove the spring lock coupling disconnect tool from the disconnected spring lock coupling.
6. Clean fittings with solvent.
NOTE: Inspect coupling for missing or damaged O-rings. If either O-ring is damaged both O-rings must be replaced. Replace O-rings or garter
springs with the appropriate replacement parts only.
INSTALLATION
1. Lubricate the O-rings with clean engine oil.
Garter Spring
2. Insert male fitting into female fitting and push together until garter spring is engaged.
3. Pull on fittings to verify coupling engagement.
