Sable V6-183 3.0L DOHC VIN S MFI (1997)
Throttle Cable/Linkage: Service and Repair
Throttle Cable Bracket
REMOVAL
1. Remove accelerator control splash shield as described.
2. Unwind cable core wire from pulley and slide end fitting out of slot on pulley.
3. If equipped, remove speed control actuator cable from throttle body control lever by sliding cable end up off pin. Remove screw retaining
accelerator cable to accelerator cable bracket.
4. If equipped, remove screw retaining speed control actuator cable to accelerator cable bracket.
5. Remove bolts retaining accelerator cable bracket to throttle body.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten screws retaining accelerator cable bracket to throttle body to 8-10 Nm (71-88 lb in). Tighten screws retaining accelerator cable and speed
control actuator cable (if equipped) to 5-7 Nm (45-62 lb in). Tighten screws retaining accelerator control splash shield to accelerator cable bracket
to 5-7 Nm (45-62 lb in).