Sable V6-183 3.0L DOHC VIN S MFI (1997)
3. Install forward clutch wave spring, clutch pack, pressure plate and retaining ring.
NOTE: Number of plates may vary with application.
4. Check the clearance between the retaining ring and the clutch cylinder lip. Clearance should be 1.02 mm-1.50 mm (0.040-0.059 inch).
5. If clearance is not within specifications, selective retaining rings are available in the Selective Retaining Ring Chart:
Selective Retaining Ring Chart
1.20-1.30 mm (0.047-0.051 inch)
1.59-1.69 mm (0.063-0.067 inch)
1.98-2.08 mm (0.078-0.082 inch)
2.37-2.47 mm (0.093-0.097 inch)
2.76-2.86 mm (0.109-0.113 inch)
3.15-3.25 mm (0.124-0.128 inch)
6. After installing correct retaining ring, recheck clearance.
Disassembly
WITH AX4N