Sable V6-183 3.0L DOHC VIN S MFI (1997)
5. Turn rear planetary support assembly over. Remove No. 16 final drive gear thrust washer (select fit) from rear planetary support assembly.
6. Using air nozzle, apply 40 psi of regulated air to low intermediate apply port to remove piston and seal assembly. Service as required.
WARNING: Always wear safety glasses when using compressed air to avoid personal injury.
NOTE: Seal is part of piston and is serviced as an assembly.
7. Use Collet D80L-100-L and Actuator Pin D80L-100-F (from Blind Hole Puller Set D80L-100-A or equivalent) and Impact Slide Hammer
T50T-100-A to remove two rear lube transfer tube seals.
CAUTION: Use care not to damage any machined surfaces.
