Sable V6-183 3.0L DOHC VIN S MFI (1997)
Pump Assembly Check Ball Location
13. Install pump cover on pump housing and install two retaining bolts. Tighten bolts evenly to 9-12 Nm (80-106 inch lbs.).
NOTE:
^
Use the pump shaft to align the pump while installing the pump cover.
^
Make sure that outer vane ring retaining pin is flush with or below the surface of the main control valve body side of the pump assembly.
Pump Assembly Check Ball Location
14. Install check ball.
15. Position control valve body separator plate and two new gaskets on pump housing. Install two Torx bolts. Tighten bolts to 9-12 Nm (80-106 inch
lbs.).