Sable V6-183 3.0L DOHC VIN S MFI (1997)
Axle Shaft: Service and Repair
Removal
CAUTION: Do not begin this removal procedure unless the following parts are available:
^
A new front axle wheel hub retainer assembly.
^
A new lower control arm-to-steering knuckle pinch bolt and nut.
^
A new driveshaft bearing retainer circlip.
Once removed, these parts must not be reused during assembly. Their torque-holding ability or retention capability is diminished during removal.
1. Remove wheel-cover/hub cover from wheel and tire assembly and loosen lug nuts.
2. After raising the vehicle on a frame contact hoist and removing the wheel and tire assembly, remove the front axle wheel hub retainer.
CAUTION: Discard the front axle wheel/hub retainer nut. It is a torque prevailing design and cannot be reused.