Sable V6-183 3.0L DOHC VIN S MFI (1997)
3. Remove stabilizer bar link top retaining nut with box end wrench while holding stud with socket.
4. Remove stabilizer bar link from front strut. Position out of way.
CAUTION: Never use a hammer to separate the outboard front wheel driveshaft joint stub shaft from the hub. Damage to the front wheel
driveshaft joint threads and internal components may result.
5. Install Front Hub Remover/Replacer T81P-1104-C and Two Stud Adapters T86P-1104-A1, Metric Hub Remover Adapters T83P-1104-BH and
Front Hub Replacer T81P-1104-A.
NOTE: make sure the hub remover adapter is fully threaded onto the hub stud and is positioned opposite the two stud adapter.
6. Push front wheel driveshaft joint only to the point that the splines are free in the hub. Remove puller (assembled tool).
