Sable V6-183 3.0L DOHC VIN S MFI (1997)
2. If equipped, install trilobe insert on inboard CV joint housing. Position in groove on outer race.
3. Using Constant Velocity Joint Grease (High Temp) E43Z-19590-A or equivalent meeting Ford specification ESP-MIC207-A, fill inboard CV
joint housing and spread remaining grease evenly inside front wheel driveshaft joint boot. Total fill is 250 grams (9 oz).
4. Install front wheel driveshaft joint on tripod assembly
Halfshaft Assembled Length Specifications
5. Remove all excess grease from CV joint external surfaces and mating front wheel driveshaft joint boot surface. Position front wheel driveshaft
joint boot over inboard CV joint housing making sure front wheel driveshaft joint boot is seated in groove. Move inboard CV joint housing in and
out, as necessary, to adjust to length shown the Halfshaft Assembled Length Specifications image.