Sable V6-183 3.0L DOHC VIN S MFI (1997)
3. Use Rotunda Knife with Offset Blade 107-R1511 and Rotunda Interior Auto-Glass Cut-Out Knife Kit 164-R2450 or equivalent to cut sealer.
CAUTION: Use care to avoid damage to the rear package tray cover panel.
4. Remove back window glass from vehicle.
5. Clean around pinch weld area to remove any dirt and debris that could contaminate the existing urethane once it is trimmed.
6. Trim remaining urethane on pinch weld to within 1 and 2.0 mm (0.04 and 0.08 inch) thickness with utility knife or razor blade. When completed,
surface should be smooth and free of cuts and contamination.
NOTE: Use extreme care not to scratch or otherwise damage the pinch weld with tools to avoid rust formation.
7. Check pinch weld sealing area for damaged sheet metal, rust or foreign objects which may have caused, or may cause, glass breakage. Service
metal if necessary.
INSTALLATION
1. If painted sheet metal has been exposed or damaged anywhere along the pinch weld, use the supplied wool applicator and apply Urethane Rubber
Primer WSB-M2G234-C or equivalent to rear window pinch weld.
NOTE: A minimum of 10 minutes is required for primer surface to dry.
2. Place on a low, stable work surface, inside up.
3. Clean back window glass with non-alcohol-based glass cleaner.
4. Using a clean wool applicator, wipe inside glass edge with Urethane Glass Cleaner WSB-M5B280-C2 21 mm (0.8 inch) wide along top and sides,
30 mm (1.2 inch) wide along bottom. Wipe off glass wipe and repeat application.
NOTE: Wipe off Urethane Glass Cleaner WSB-M5B280-C2 or equivalent immediately after application because it flash-dries. Prep application
must be applied twice.
