Sable V6-183 3.0L DOHC VIN S MFI (1997)
5. Properly align back window glass to body:
a. Place back window glass into opening. Center it top and bottom, side to side.
b. Using masking tape or crayon, make alignment marks at points on four sides of both back window glass and window opening.
6. Remove back window glass from vehicle and place it back on work table.
7. Thoroughly shake and stir Urethane Glass Cleaner WSB-M2G314-B or equivalent to make sure of uniform pigment mixing.
8. Using a clean wool applicator, apply primer to inside glass edge 21 mm (0.8 inch) wide along top and sides and 30 mm (1.2 inch) wide along
bottom.
NOTE: Allow a minimum of five minutes for glass primer to dry.
9. Apply an even bead of Urethane Adhesive WSB-M2G316-B or equivalent around entire sheet metal flange on top of existing bead of urethane.
The bead should be triangular in shape, 16 mm (0.625 inch) high and 8 mm (0.33 inch) at base.
NOTE: Leave a door window slightly open until adhesive is cured.
10. Install back window glass onto vehicle, taking care to align marks on glass to body. This must be done before adhesive skins over.
CAUTION: When replacing urethane installed glass parts, do not drive the vehicle until the urethane has cured. At temperatures above 21°C (70°
F) and relative humidities above 50%, adequate cure time is typically 24 hours (less at higher temperatures and higher humidities). See detailed
instructions provided by the urethane manufacturer. Inadequate or improper curing can adversely affect the retention of the windshield.
11. Reconnect rear window defroster wires.
12. Remove spacer and install headliner. Install all garnish mouldings.
13. Check installation for air and water leaks in urethane seal.
CAUTION: Use only urethane for service of air and water leaks in urethane set back windows.
