Sable V6-183 3.0L DOHC VIN S MFI (1997)
Quarter Window Glass: Service and Repair
Removal and Replacement
REMOVAL
WARNING: SAFETY GLASSES AND GLOVES MUST BE WORN. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY.
1. Remove interior trim panels. See: Body and Frame/Doors, Hood and Trunk/Doors
2. From inside vehicle, remove five mounting nuts retaining quarter window glass.
3. Using Rotunda knife with Offset Blade 107-R1511, or Rotunda Interior Auto-Glass Cut-out Knife Kit 164-R2450 or equivalent, cut urethane seal
around entire edge of quarter window glass.
NOTE: If quarter window glass is shattered, cutting urethane seal is also permissible.
4. Remove quarter window glass.
5. Remove urethane from flange leaving 1-2 mm thickness, using a razor blade or utility knife.
INSTALLATION
1. Using a clean wool applicator, apply Urethane Rubber Primer WSB-M2G234-C or equivalent to any sheet metal that has been exposed along the
window opening flange.
NOTE: A minimum of 30 minutes is required for primer surface to dry.
2. Using a lint-free cloth, wipe the 10 mm (3/8 inch) wide glass track on inside surface of window module with Urethane Glass Cleaner
WSB-M5B280-C2 or equivalent.
NOTE: Wipe off cleaner immediately after application before it flash-dries.
3. Using a clean applicator, apply Urethane Glass Cleaner WSB-M2G314-B or equivalent to the 10 mm (3/8 inch) wide glass track on inside surface