Sable V6-183 3.0L DOHC VIN S MFI (1997)
Wiper Arm: Service and Repair
Front
REMOVAL
1. Turn ignition switch to RUN. Turn multi-function switch to LO. Allow windshield wiper motor to move the windshield wiper mounting arm and
pivot shafts three or four cycles, then turn OFF the multi-function switch. This will place the windshield wiper mounting arm and pivot shafts in
the park position.
2. Turn ignition switch OFF.
3. Observe wiper position through the park position marks in the blackout area at the base of the windshield.
4. Remove windshield wiper output arm cover from windshield wiper pivot arm by inserting a flat-blade screwdriver at the rear and lifting
windshield wiper output arm cover off.
5. Remove nut retaining windshield wiper pivot arm to windshield wiper pivot shaft.
6. Turn ignition switch to RUN. Turn windshield wiper switch to LO and allow wipers to move to a straight-up-and-down position. Turn ignition
switch OFF to stop wipers in this position.
CAUTION: Before reinstalling windshield wiper blade and arm assemblies, turn ignition switch to RUN, turn wiper switch to LO or HI, and then
turn wiper switch OFF to cycle the wipers and allow them to park. Failure to cycle the wipers may result in incorrect wiper arm positioning
causing the wipers to travel past their intended wipe area and possibly damage the vehicle.
7. Remove windshield wiper pivot arms by lifting straight up off pivot shafts.
INSTALLATION
